Chapter 1: Introduction
4 System configuration
1.4 System configuration
The SAILOR 6080 Power Supply is
designed to be used with BGAN-X
and FleetBroadband terminals. It can
be used as a stand-alone DC power
supply or as a building block in a
larger power supply.
When more power is needed than
one power supply can give, i.e.
300 W, you can stack up to four
power supplies on top of each other
and connect them.
1
When stacking two, three or four
units the load on each of the units is
automatically balanced among the
units.
1. Vertical mounting is recommended, particularly if more than two units are
stacked. If the system is powered from an emergency battery and more
than 2 units are connected, the units must be connected in parallel, see
Wiring 3 or more SAILOR 6080 units on page 27.
To Next Page
Loading...
Need help?
General
