Chapter 2: Operation
Operation – SAILOR 6004 Control Panel 11
22222
Operation
Filters for stations
The SAILOR 6390 Navtex Receiver can automatically filter messages from
coast stations within a certain range of own position, measured in NM. It
can also filter coast stations manually (default). For a list of stations see the
Admiralty List of Radio Signals and ITU List of Coast stations and Special
Service Stations (List IV) (http://www.itu.int).
To set up filters for stations do as follows:
1. From any list of messages (Unread, Tagged or All), tap the menu icon
and then Filters.
2. Tap Printer, Display or INS to select the output for this filter.
3. For automatic filtering select Automatic Mode.
The coast stations within the currently set range are displayed.
1
4. For manual selection deselect Automatic Mode and tap the
frequency you want to set up a filter for, e.g. 490 kHz Stations.
Swipe and select the stations you want to receive on this frequency.
5. Tap Apply. The selected stations are displayed directly below the
frequency.
1. For Automatic Mode the SAILOR 6390 Navtex Receiver must have a valid
GPS input. Without a valid GPS input it can only filter manually.
Note
Make sure that the stations for Printer are also included in the
stations for Display. If not, SAR, Nav or Met warnings sent only to
the Printer cannot be displayed and read.
98-137261.book Page 11 Wednesday, February 19, 2014 2:06 PM