Chapter 3: Service & maintenance
20 Alarms and notifications
Installation with SAILOR 6004 Control Panel
If the connection between the SAILOR 6390 Navtex Receiver and the
SAILOR 6004 Control Panel is lost, the SAILOR 6004 Control Panel shows
an error “Connection lost”. Make sure that no one is connected to the
SAILOR 6390 Navtex Receiver using the Service Interface.
Alarm Description Remedy
001 Navigational Warning Read associated message.
002 Meteorological Warning Read associated message.
003 Search and Rescue Information Read associated message.
004 Receiver Malfunction Contact your supplier.
005 Built-in Self Test Failure Check antenna installation.
006 General Failure Power cycle the unit. If this does
not help, contact your suplier.
067 GNSS position lost Check the GPS input.
068 Automatic mode disabled (no
fix)
Check the GPS input. Without a
valid GPS input the automatic
mode does not work.
Table 4: Navtex alarms
Alarm Description Remedy
060 Printer is offline Set online.
061 Printer is busy Wait until current print job is finished.
062 Printer is low on paper Insert more paper.
063 Printer is out of paper Insert more paper.
064 Printer not connected Check the printer connection.
a
065 Printer error See the original printer documentation.
066 No default printer
configured
This must be set up during installation.
Contact your installation centre.
Table 5: Navtex alarms, printer
a. Alarm 064 is the only alarm output for 3rd party print servers.
98-137261.book Page 20 Wednesday, February 19, 2014 2:06 PM
To Next Page
Loading...
Need help?
General
