INSTALLATION MANUAL 4600 CAN/PLIP
17
6.8 - Emergency disarming.
If the vehicle original remote control get lost or if it doesn’t work, open the door with the mechanical key and turn the
ignition key ON. If the system doesn’t disarm automatically follow the emergency procedure described in the user manual.
6.9 - Alarm condition.
When the system goes off (alarm ON) the siren sounds and the direction lights fl ash for 28 s.
6.6 - Emergency panel LED.
The LED main scope is to show the system arming and disarming conditions. When the system is armed the LED gets
ON and remains illuminated until the 25 s arming period has elapsed. After that it starts blinking. It goes OFF as soon
as the system is disarmed.
6.7 - Alarms memory.
If the system has gone off (alarm on) during the arming time it will warn you with 3 fl ashes of the direction lights and 3
audible signals (5 audible signals if the arming/disarming audible signals function has been activated). It also stores in
its memory the reason of the occurred alarm and shows it on the emergency panel LED. Count the number of fl ashes
and check the corresponding alarm reason on the table. By turning the key ON the memory will be deleted.
LED NUMBER OF FLASHES ALARM ROOT CAUSE
1 fl ash Door opening detection.
2 fl ashes Ultrasonic volumetric detection.
3 fl ashes Bonnet opening detection.
4 fl ashes Ignition key ON detection.
5 fl ashes Boot opening detection.
6 fl ashes Door opening detection.
7 fl ashes Additional sensors.
8 fl ashes Siren cable cutting - Cobra Bus.
9 fl ashes US module connected to the Cobra Bus.
10 fl ashes Module connected to the Cobra Bus.
11 fl ashes Immobilizer 1 module connected to the Cobra Bus.
12 fl ashes Immobilizer 2 module connected to the Cobra Bus.
13 fl ashes Keyboard module connected to the Cobra Bus.
14 fl ashes Not used.
To Next Page
Loading...
Need help?
General
