9
2.7. Alarm status light (LED)
The status LED is used to provide information to the user during normal operation and as
well as a diagnostic tool.
Pre-arm state (30 sec arming time)
LED flashes (at a steady rate)
LED flashes (at a steady rate)
LED On when entering the mode (after
flashes)
Number of flashes gives feedback from alarm
trigger (see chapter 3.6. Alarm memory)
2.8. Battery back-up siren
The alarm system is specified with a rechargeable battery back-up siren. The siren battery
is fully recharged after approximately 12 hours of driving.