Setup Options
Microphone Record Sensitivity
If the recorder is in Time mode, press to enter
Standby mode.
Press and hold 1. to enter Setup mode (the LCD
should read “SET”).
Press 2.
once. The LCD will display “SET mic: HI” or
“SET mic:LO”.
Press 3.
or to change the setting between
“HI” and “LO”.
Use the “LO” setting to record sounds that are
very close to the microphone. Use the “HI”
setting to record sounds that are further away
from the microphone.
When all settings have been completed, press 4.
to return to Standby mode.
Voice-Activated Recording (VAS)
If the recorder is in Time mode, press to enter
Standby mode.
Press and hold 1. to enter Setup mode (the LCD
should read “SET”).
Press 2.
twice. The LCD will display “SET OFF” and
the VAS indicator [ ] will appear on screen.
Press 3.
or to change the setting between
“OFF” and “ON”.
Use the “OFF” setting to record from the micro-
phone continuously when recording.
To Next Page
Loading...
Need help?
General
