©2020 McDonald’s | ©2020 The Coca-Cola Company | Freestyle at McDonald’s | User Guide | Confi dential | 15
Locate the nozzle tip. Use the
Nozzle Tip Wrench (Coke® part
#161294) and twist nozzle tip
counter-clockwise. Then pull
down to remove.
Place nozzle tip in approved sanitizer solution (Kay-5).
Shake nozzle tip when submerging to remove any air
bubbles and soak the nozzle tip for no more than 5 minutes.
CAUTION: DO NOT SOAK NOZZLE TIP OVERNIGHT!
NOTE: If using Kay-5, add 1 oz packets to 2.5 gallons of clean, warm water.
Scrub the nozzle tip at a
45° angle with approved
detergent cleanser using the
blunt end of the Nozzle
Tip & Injector Ring Brush
(Coke part #149326).
Scrub underneath the injector ring (area where the nozzle
connects) using the thick bristled nozzle brush at a 45°
angle and a clean sanitized towel. Focus on the small
holes where ingredient comes out. Allow to sit for 2
minutes. Then repeat with clean sanitizing solution.
Rinse nozzle tip in warm,
clean, drinkable water.
Allow the nozzle tip and injector ring area to .
Then use the Nozzle Tip Wrench to reinstall nozzle tip
and lock into place turning clockwise.
NOTE: Take extra care to ensure the nozzle tip is inserted completely
and locked into place. Be sure to clean the Nozzle Tip Wrench and
Brush when completed.
Follow these procedures to properly clean the Freestyle® at McDonald’s nozzle tip and injector ring. Always follow McDonald’s
sanitation policies, including expectations to wash hands and to use clean water and approved food grade sanitizer.
Cleaning Nozzle Tip and Injector Ring
Cleaning & Maintenance
52
41
63
To Next Page
Loading...
