16 Advanced Programming
page 22 of 45 GU-139-Z1
IA4100
Administrator Guide
Code Blue
• 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com
Information programmed into the phone is represented by . When the instructions call for
entering 1#, simply press 1 and the default password, followed by the # (pound) symbol on your
telephone keypad. For example, the default password on the IA4100 is 2583. To put the IA4100
into Program Mode, dial 12583#.
When you enter a command (CMD) correctly, the unit will respond with a single beep (DTMF “B”).
If a command has been entered incorrectly, the unit will respond with a rejection triple beep
(DTMF “BBB”). When commands are met with a triple beep, the command has not been accepted
and will not affect the programming of the unit.
All necessary commands can be entered during one programming session. Any time the unit
responds (with either a single beep or a rejection triple beep), it is capable of accepting another
command.
When you first dial into the IA4100 speakerphone you will hear a Request For Acknowledgment
(RFA) tone. If a response from you is not received within seven (7) seconds the IA4100 will
remain in two-way audio mode and accept In Call Commands (section 5.2). Because the unit has
not yet been programmed, you should dial 12583# on your touch-tone keypad to enter Program
Mode.
The unit can be forced to hang up by depressing the * (star) followed by the # (pound) symbols on
the telephone keypad. If the *# sequence is not used to hang up the IA4100, the phone is
programmed to recognize a Disconnect Supervision such as a WINK or reverse polarity signal
from the PBX or PSTN. Also available is a Silent Time Out (CMD 42), reorder tones or revert to dial
tone. The speakerphone will hang up once it has received any of these standard end of call
signals. If none of those Supervised Disconnects occur, the speakerphone will stay active (i.e.,
Call received LED light stays on) after the called party has hung up or until the Call Timer expires.
NOTE: You MUST program the speakerphone after installing the Code Blue unit.
To Next Page
Loading...
