Name: Code CR1500
Brand: Code
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Table of Contents

Web Generated Configuration Guide

For questions regarding reader configuration contact support@codecorp.com.

General Reading Mode Settings.................................................................................................................................. 8-9

Continuous Scan Mode On................................................................................................................................................................... 8 (A2)

Motion Detect/Continuous Scan Off (Out of Stand) - Default......................................................................................................... 8 (A3)

Motion Detect Always On...................................................................................................................................................................... 8 (A4)

No Motion Detection Delay................................................................................................................................................................... 8 (B1)

500ms Motion Detection Delay - Default........................................................................................................................................... 8 (B2)

Enable Cell Phone Reading Enhancement.......................................................................................................................................... 8 (B3)

Disable Cell Phone Reading Enhancement - Default........................................................................................................................ 8 (B4)

Set Motion Detect Maximum Brightness to 25%.............................................................................................................................. 8 (C1)

Set Motion Detect Maximum Brightness to 50%.............................................................................................................................. 8 (C2)

Set Motion Detect Maximum Brightness to 75%.............................................................................................................................. 8 (C3)

Set Motion Detect Maximum Brightness to 100% - Default........................................................................................................... 8 (C4)

Enable Target LED During Image Capture - Default........................................................................................................................ 8 (D1)

Disable Target LED During Image Capture........................................................................................................................................ 8 (D2)

Trigger Mode On In Stand................................................................................................................................................................... 8 (D3)

Motion Detection On In Stand - Default............................................................................................................................................ 8 (D4)

Continuous Scan Mode On In Stand.................................................................................................................................................. 8 (E1)

Trigger Mode On Out of Stand - Default.......................................................................................................................................... 8 (E2)

Motion Detection On Out of Stand..................................................................................................................................................... 8 (E3)

Continuous Scan Mode On Out of Stand........................................................................................................................................... 8 (E4)

Enable Stand Detection - Default....................................................................................................................................................... 9 (A1)

Disable Stand Detection........................................................................................................................................................................ 9 (A2)

Reader Text Commands Off - Default................................................................................................................................................ 9 (A3)

Reader Text Commands On.................................................................................................................................................................. 9 (A4)

Beep On Vibrate On - Default............................................................................................................................................................ 9 (B1)

Beep Off Vibrate On............................................................................................................................................................................. 9 (B2)

Beep On Vibrate Off............................................................................................................................................................................. 9 (B3)

Beep Off Vibrate Off............................................................................................................................................................................. 9 (B4)

Targeting On - Default......................................................................................................................................................................... 9 (C1)

Targeting Off.......................................................................................................................................................................................... 9 (C2)

Beep Volume 0%................................................................................................................................................................................... 9 (C3)

Beep Volume 33%................................................................................................................................................................................. 9 (C4)

Beep Volume 67%................................................................................................................................................................................. 9 (D1)

Beep Volume 100% - Default............................................................................................................................................................. 9 (D2)

Data Formatting (Prefix/Suffix) Settings..................................................................................................................... 9-10

Disable Data Formatting - Default..................................................................................................................................................... 9 (D4)

Prefix Comma......................................................................................................................................................................................... 9 (E1)

Prefix Space........................................................................................................................................................................................... 9 (E2)

Prefix Tab (USB Keyboard Mode Only)................................................................................................................................................ 9 (E3)

Prefix Tab (RS232 Mode Only)............................................................................................................................................................. 9 (E4)

Erase Prefix Data.................................................................................................................................................................................. 10 (A1)

Suffix Comma......................................................................................................................................................................................... 10 (A2)

Suffix Space........................................................................................................................................................................................... 10 (A3)

Suffix Enter (USB Keyboard Mode Only) - Default............................................................................................................................ 10 (A4)

Suffix Tab (USB Keyboard Mode Only)................................................................................................................................................ 10 (B1)

Suffix Tab (RS232 Mode Only)............................................................................................................................................................ 10 (B2)

Suffix Carriage Return (RS232 Mode Only)........................................................................................................................................ 10 (B3)

Suffix Carriage Return Line Feed (RS232 Mode Only) - Default.................................................................................................... 10 (B4)

Suffix Line Feed (RS232 Mode Only).................................................................................................................................................. 10 (C1)

Erase Suffix Data.................................................................................................................................................................................. 10 (C2)

Convert Barcode Data to Uppercase................................................................................................................................................... 10 (C3)

Convert Barcode Data to Lowercase................................................................................................................................................... 10 (C4)

Convert Barcode Data to Bracketed Hex Output............................................................................................................................... 10 (D1)

Erase Prefix & Suffix Data.................................................................................................................................................................. 10 (D2)

Prefix AIM ID Off - Default................................................................................................................................................................. 10 (D3)

Prefix AIM ID On................................................................................................................................................................................... 10 (D4)

Symbology Settings........................................................................................................................................................ 10-20

Australian Post On................................................................................................................................................................................ 10 (E2)

Australian Post Off - Default.............................................................................................................................................................. 10 (E3)