Code CR900FD User Manual

4/14/2016
D014465 CR1400 CR1000 CR2300 CR2600 CR3600 CR44X5 CR8000 CR900FD CR6000 CR5000 T500 Client Version ICD
Page 47 of 106
© 2013-2016 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  (801) 495-2200  FAX (801) 495-0280
Reg
Setting Name
Default (Hex)
Comment
50
Aztec Symbology
1
Binary Dip Switch
Bit
Controls
Value
0
Aztec Decoding
0: Disabled
1: Enabled
1
Inverse Aztec Decoding
0: Disabled
1: Enabled
2
Mirror Aztec Decoding
0: Disabled
1: Enabled
Note: This register has no effect on a CR900FD without the
proper 2D barcode decoding license.
Keywords: #Aztec
53
Decoder HD field (FOI
0) Width
280
(#640)
Valid Range: 1 to 640 pixels
Decoder uses only the specified pixel width in the HD field (FOI
0). See section 9.2
Note: The High Density field (FOI 0) does not exist on the
CR900FD.
54
Decoder HD field (FOI
0) Height
3C0
(#960)
Valid Range: 1 to 960 pixels
Decoder uses only the specified pixel height in the HD field
(FOI 0). See section 9.2
Note: The High Density field (FOI 0) does not exist on the
CR900FD.
55
Notify Of Read Failure
0
0: Disabled
1: Send “r” packet on no-read (See “r” packet in Section 6.2)
0x100xx: post event on no-read, where the lower 8 bits specify
the event number. For example, 0x10009 to post Event
0x09.
Note: Register C4 contains the list of valid events.
Keywords: #DefaultEvent
59
Beep Duration
64
(#100)
Valid Range: 0 to 7FFFFFFF Milliseconds
Affects beep and vibrate duration.
Keywords: #Beep

Code CR900FD Specifications

General

Brand	Code
Model	CR900FD
Category	Barcode Reader
Language	English