EasyManuals Logo

Code CR900FD User Manual

Code CR900FD
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
4/14/2016
D014465 CR1400 CR1000 CR2300 CR2600 CR3600 CR44X5 CR8000 CR900FD CR6000 CR5000 T500 Client Version ICD
Page 50 of 106
© 2013-2016 The Code Corporation
12393 South Gateway Park Place Suite 600, Draper, UT 84020
(801) 495-2200
FAX (801) 495-0280
Reg
Setting Name
Default (Hex)
Comment
76
Send And Store Mode
0
0: Normal mode (buffered send)
1: Send and log mode
3: Log only mode
Note: Only applies to readers using Bluetooth® communication
modes.
Also see register: B4. Reader will not allow the user to set
auto-reconnect on, and store data. If any setting that allows
storing data is turned on, auto-reconnect will be turned off (if
it is on).
Keywords: #DataRetention
78
Settings Lock
1
1: Settings unlocked
3: Settings locked (except settings Lock)
85
Tri-Optic Options
0
Binary Dip Switch
Bit
Controls
Value
0
Tri-Optic Decoding, Normal
Quiet Zones
0: Disabled
1: Enabled
1
Allow Short Quiet Zones
0: Disabled
1: Enabled
2
No Quiet Zones Required
0: Disabled
1: Enabled
3
Reverse order of first and
second halves
0: Disabled
1: Enabled
86
Motion Detection:
Event
3
Valid Range: Any event as defined in register 39 and re-listed
in C4
Motion detection is enabled by setting register C4 to 0xF0.
This register is reset to 0 (disabled) when register C4 is
changed away from 0xF0. When motion is detected, this event
is posted.
See register 39 or C4 for list of events.
Keywords: #MotionDetection

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Code CR900FD and is the answer not in the manual?

Code CR900FD Specifications

General IconGeneral
BrandCode
ModelCR900FD
CategoryBarcode Reader
LanguageEnglish

Related product manuals