Code CR900FD User Manual

4/14/2016
D014465 CR1400 CR1000 CR2300 CR2600 CR3600 CR44X5 CR8000 CR900FD CR6000 CR5000 T500 Client Version ICD
Page 52 of 106
© 2013-2016 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  (801) 495-2200  FAX (801) 495-0280
Reg
Setting Name
Default (Hex)
Comment
93
Suppress Beep On
Decode
0
0: Beep indicating decode before JavaScript processing
1: Call JavaScript without beeping to indicate decode
Normally, the Reader beeps as soon as decodes are read and
processes them via JavaScript if necessary after the beep. To
enable JavaScript to control the beep feedback, change this
setting to 1; this will suppress the beep; the JavaScript would
typically beep if the decode is valid or start another read cycle
if it isn’t.
This setting does not suppress beeps for anything but a
successful decode event.
Keywords: #Beep
98
Decoder HD field (FOI
0) X Offset
0
Valid Range: 0 to 639 pixels
Decoder uses the pixels after the specified pixel offset in the
HD field (FOI 0). See section 9.2
Note: The High Density field (FOI 0) does not exist on the
CR900FD.
99
Decoder HD field (FOI
0) Y Offset
0
Valid Range: 0 to 959 pixels
Decoder uses the pixels after the specified pixel offset in the
HD field (FOI 0). See section 9.2
Note: The High Density field (FOI 0) does not exist on the
CR900FD.
9A
Decoder Wide field
(FOI 1) X Offset
0
Valid Range: 0 to 639 pixels
Decoder uses the pixels after the specified pixel offset in the
Wide field (FOI 1). See section 9.2
9B
Decoder Wide field
(FOI 1) Y Offset
0
Valid Range: 0 to 959 pixels
Decoder uses the pixels after the specified pixel offset in the
Wide field (FOI 1). See section 9.2

Code CR900FD Specifications

General

Brand	Code
Model	CR900FD
Category	Barcode Reader
Language	English