CODEL
Operation and Maintenance Manual
Issue : A Rev. : 3 Date : 13/11/2018 Ref. : 100351
P a g e | 27
Remove the 6x nuts from the four corners of the E-Cell, along with the washers. Ensure that these are kept
safe.
Figure 12: E-Cell PCB Removal
Slowly remove the E-Cell from the Unit.
Insert the new E-Cell in to the unit, observing the cell orientation and replace the nuts and washers.
Re fit the ribbon cable, and re bolt the enclosure lid
NOTE: Failure to replace cells will invalidate the warranty and performance of the analysers after this
time cannot be guaranteed.
To Next Page
Loading...