COEF MP 700 ZOOM - Troubleshooting

Pag. 16 http://www.coef.it - info@coef.it
11.0 TROUBLESHOOTING
PROBLEM CAUSE ACTION
Theprojectordoesn’t swich on
Theprojectorswiches on but
doesn’tanswer to commands
Defecting projection
Projection withhalo
Thecolor or other effectsdoesn’t
coincidetothe selectedvalue.
The PAN or TILT movement
doesn
’t coincidetothe selcted
value
Theprojectordoes not carry out
theautomatic repositioning of the
PAN or TILT movements.
- The powersupply is not present
- The lamp is not working
- Thethermalswitch is active
- Wrong DMX configuration
- Defectivecable
s
- LEDAis off
- Defective controlunit
- The lens isbroken
- Dustorgrease stored on theall
parts of projector
- Dustorgrease stored on theall
parts of projector
- Position sensordirty with dustor
greas
e
- Defective motor
-Electronic board
- Defective motor
-Electronic board
-ENCO off in the PAN/TILT confi-
guration menu(cap. 6.0)
Check if the luminous indicator islighted
or not.
Replace the lamp.
Just to wait forlittle of time.
Make surethat theprojector is corr
ectly
configurated.
Replace orrepair the DMX cable.
Check the controlunit & DMX cable.
Check the controlunit by means of other
working projectors.
Technical aid isrequired.
Check that the lens are not broken.
Remove
dustorgrease stored on lenses.
Carefully clean the opticalgroup lenses
and theprojector components(see “Main-
tenance” chapter).
Carefully clean the opticalgroup lenses
and theprojector components(see “Main-
tenance”).
Technical aid i
srequired.
Carefully clean the opticalgroup lenses
and theprojector components(see “Main-
tenance”).
Technical aid isrequired.
Set ON ENCO Function of PAN/TILT con-
figuration menu(cap. 6.0).