http://www.coef.it - info@coef.it Pag. 5
3.0 INSTALLATION
The constructor is not be considered responsible in case of:
•
Improper use of the unit or use by not trained staff
•
Use in contrast with the directions on work safety
•
Wrong installation
•
Defective power supply
•
Serious lacks in the necessary maintenance
•
Unauthorized modifications and interventions
•
Use of spare parts that are not original or not specific for the unit
•
Total or partial inobservance of instructions
•
Unusual events
3.1 LAMP MOUNTING OR REPLACING
•
Switch off the projector before operating.
•
The lamp used in the fixture is a high pressure lamp and must be handled very carefully.
• The unit is realized to use only MSR700 lamp; absolutely don’t use other types of lamp.
• The lamp must be changed if damaged or deformed by heat.
• Wait at least 15 minutes after the projector has been switched off before operating again, in order to let it cool down
and avoid the lamp explosion.
• Wear protection gloves and glasses.
• Read carefully the lamp builder’s instructions.
• Don’t look directly the lamp.
Wait 30 minutes in order to avoid burns.
Unscrew with across screwdriver thefirst screw A for a singleturn;unscrew the second one completely B;
unscrew completely the screw A and to removethecover th
at supports the lampholder.
Insert delicately the lamp in theprojectorsupport,driving it with the round cover.
Pay attention: the lampholder’s wires mustcorrectly reenter in theprojector. Block thecove
rscrewing the screws
up ( part. A-B).
WARNING: read carefully
To Next Page
Loading...
