WARNINGS
(1) THE MACHINE MAINS CABLE MUST BE CONNECTED TO THE
SUPPLY VIA A SAFETY ISOLATOR SWITCH WHICH PROVIDES A
CONTACT SEPARATION OF AT LEAST 3mm.
(2) REPLACEMENT OF THE Y TYPE MAINS CABLE REQUIRES
SPECIAL TOOLS. SHOULD THE CABLE BECOME DAMAGED,
REPLACEMENT MUST ONLY BE CARRIED OUT BY A TRAINED
PERSON FROM AN APPROVED SERVICE AGENT.
(3) ENSURE THAT THE SUPPLY TO THE ISOLATOR SWITCH IS
ISOLATED BEFORE MAKING ANY CONNECTIONS TO IT.
(4) ENSURE THAT THE SUPPLY TO THE MACHINE IS ISOLATED
BEFORE MAKING ANY CONNECTIONS TO THE TERMINAL BLOCK
AT THE REAR OF THE MACHINE.
(5) THE DISPENSING MACHINE MUST BE EARTHED.
Connect the beverage machine, via a safety isolator switch with a contact
separation of at least 3mm, to a 230V~, 50Hz, 13A supply. Note that
replacement of the Y Type mains cable requires special tools. Should the cable
become damaged, replacement must only be carried out by a trained person
from an approved service agent.
Preferably, the isolator switch should be located behind the machine to prevent
accidental damage or misuse.
Fuse Layout & Function
To Next Page
Loading...