shot of water.
Note. Only occurs on last cycle of
multi-cycle drinks.
Under some circumstances it is
desirable to have a pause between
cycles of a multi-cycle selection.
Theses variables provide the means
to achieve this.
VEND DELAY
010 (Duration)
Number of times settings repeat. For
example set to 2 for a two cup pot.
Scale factor applied to basic drinks
settings. To accommodate different
drink sizes. Operates on all settings
together.
To adjust the drink, first select the parameter you wish to change. For example to
adjust the Coffee strength scroll through to the parameter controlling the run time for
the coffee ingredient motor. The display will show for example:
COFFEE
010 (DUR)
Press ENTER - display will show:
COFFEE
VALUE = 012 (FLASHING DIGIT)
Press to increase or to decrease.
Press ENTER to accept the new value.
Press to step through program to adjust other value or press ESC to return to
SELECT DRINK TO MODIFY, then press ESC again to return to normal operating
mode.
SELECT DRINK TO TEST
20. The SELECT DRINK TO TEST option allows any selected drink to be dispensed, while still
in the Engineer's Program, in order to be tested. This facility is useful for testing a drink
that has been modified.
Press DRINK A, for example, to test a change made to the selection in the SELECT DRINK
TO MODIFY option.
MOVE OR COPY DRINK
21. The MOVE OR COPY DRINK option facilitates the rapid movement or cloning of a drink to
another physical button on the keyboard. This is to aid the customization of menus to suit
requirements in the field on an individual machine basis. Three options are available.
To Next Page
Loading...
