COFFEtek VITRO S3 RANGE - Page 32

COFFEtek LTD
VITRO S3
Revision 1
28/02/2017
32
MACHINE SETTINGS
40.
Settings
Description
OUT OF
SERVICE
0
Enables machine to be programmed out of
service:
Setting this to 1 sets the machine out of service
GLOBAL
SCALING
100
Adjustment of cup volume of drinks. All aspects of drink are scaled, i.e. product,
whipper, water.
DRY VEND
FLAG
0
Enables product only operation:
0 = Water On, 1 = Water Off
SERIAL
NUMBERS
The machines serial number can be entered so that it can be viewed on the LCD
display. By default this facility is disabled.
BEHAVIOUR
CODE
Status Display, STANDARD being the default.
BEHAVIOUR 1 – Debug setting for Coffetek Software engineers only.
FLUSH TIME OUT – The machine will function normally until the number of hours
set in the FLUSH TIME HRS
setting passes then the machine will inhibit all the vends until the machine has
been flushed.
COLD WATER OUT – If the machine is fitted with a chiller kit to produce cold
vends.
EXTERNAL PUMP – If the machine is fitted with an external pump kit i.e. Whale
Pump.
INGRED MONITOR – Will allow the machine to monitor how much product is
being dispensed per drink to prevent a purely water vend being produced.
EXT WASTE SENSOR – If the machine is fitted to a base cabinet or side unit
with a waste kit to remove the coffee grouts and water this heading must be
turned on.
STATUS
DISPLAY
001
Will show on the internal display what the machines current boiler status is
LANGUAGE
 This setting changes the language of the software. Great care
should be taken when changing this value.
SILENT KEYS
 When set to one this variable disables the beep when a key is
pressed on the machine. Note that this does not disable the buzzer
completely; all other sounds warning or otherwise will still be