IMPORTANT: BEFORE PERFORMING ANY SERVICE ON THE TUB. MAKE A VISUAL INSPECTION
OF THE TUB TO GET AN UNDERSTANDING OF WHAT CONDITION IT MAY BE IN AND IF
ANYTHING LOOKS OUT OF THE ORDINARY. IF ANY PART APPEARS TO BE DAMAGED,
LOOSE OR MISSING, DO NOT PROCEED. CONTACT TECH SUPPORT IMMEDIATELY.
Your tub control has been specically designed so that by simply connecting the tub to its properly grounded
source, and following the start-up procedures in this manual, the tub will automatically cool to the set tem-
perature. You can adjust the set temperature by pressing the up or down arrows on your control panel to the
desired temperature.
TEMPERATURE DISPLAYED IN FAHRENHEIT OR CELSIUS
Press and hold the Light Key for 5 seconds to toggle between Fahrenheit and Celsius.
The topside control panel has buttons which you press to set the temperature, initiate the ltration cycle, turn
the light on, and activate or deactivate the pump(s). The topside control panel display responds to let you
know you have pressed a button, and that the selected function has been performed.
SETTING WATER TEMPERATURE
Use Up or Down arrow key to regulate water temperature. The temperature setting will be displayed for 5
seconds to conrm your new selection.
The “Set Point” symbol indicates the desired temperature, NOT the current water temperature.
Water temperature can be adjusted by 1- degree increments from 42-104F (5.5 - 40ºC).
1.11 Topside Control Panel
1.10 Venturi Controls
The Venturi Controls allow you to control the intensity of the massage at each jet by adjusting the mixture of air
and water. Simply turn the venturi control lever counter clockwise for a stronger ow and clockwise for a
softer ow. ( Not available on Icekube or Icepod models )
11
To Next Page
Loading...