COLDTUB Icekube - Fill Tub with Water Power up Tub and Set Water Temperature

The following steps provide guidance to help establish correct chemically balanced water. To help
ensure chemicals dissolve appropriately it is good practice to rst mix/dissolve the chemical in an
uncontaminated container of hot water before carefully adding to the Tub water.
Note: The following steps take into account that your Tub has water above the COLDTUB Pal Sensor
Housing, removed the COLDTUB Pal Sensor Plug, installed the COLDTUB Pal Sensor Housing Grate
and installed the COLDTUB Pal Sensor.
WARNING: Do not proceed until your Tub water is above the COLDTUB Pal Sensor Housing,
removed the COLDTUB Pal Housing Plug, installed the COLDTUB Pal Sensor Housing Grate
and installed the COLDTUB Pal Sensor. or you have obtained further direction from your
Dealer.
Steps to Fill Tub With Water Power Up Tub and Set Water Temperature
STEP 1. FILL TUB
Fill your Tub through half way up the skimmer box as shown
to the appropriate level.
STEP 2. CONNECT/TURN ON ELECTRICAL POWER TO
THE TUB
Once the Tub is lled to the proper level, connect power to the
Tub in accordance with the COLDTUB Owners Manual, and
turn the power on to the Tub on.
STEP 3. SET WATER TEMPERATURE
Set the water temperature control on the settings to the
desired temperature (between 42ºF and 104ºF or 5.5°C and
40°C).
Spa Boy Owners Manual
Spa Boy Owners Manual Version 1 Revision 1 (R1)
Page 14 of 35 Issued 20 Nov 2014
1.14.2 Fill Spa With Water Power Up Spa and Set Water
Te
mperature
The following steps provide guidance to help establish correct chemically balanced water.
To help ensure chemicals dissolve appropriately it is good practice to first mix/dissolve the
chemical in an uncontaminated container of hot water before carefully adding to the spa
water.
Note: The following steps take into account that the Spa Technician has filled your spa
with water to above the Spa Boy Sensor Housing, removed the Spa Boy Sensor Plug,
installed the Spa Boy Sensor Housing Grate and installed the Spa Boy Sensor.
Warning: Do not proceed until the Spa Technician has filled your spa with water
to above the Spa Boy Sensor Housing, removed the Spa Boy Housing
Plug, installed the Spa Boy Sensor Housing Grate and installed the Spa
Boy Sensor. or you have obtained further direction from your Dealer.
Steps to Fill Spa With Water Power Up Spa and Set Water Temperature
Step 1. Fill Spa
Fill your spa through the filter intake as shown to the
appropriate level (just under the head rests). If you have
sediment or high mineral content a “carbon filled pre-filter”,
as pictured, can help. (This is optional and will prolong
the fill time).
Step 2. Connect/Turn on Electrical Power to the Spa
Once the spa is filled to the proper level, connect power to
the spa in accordance with the Arctic Spas Owners Manual,
and turn the power on to the spa on.
3.10.2 Fill Tub With Water Power Up Tub and
Set Water Temperature
53