Coleman 9280A108 User Manual

Frame Pole Assembly
–The frame is a unique one piece
shock-corded design
–Step 1: Assemble the ridge pole.
(illus. 1)
–Step 2: Extend each leg fully by
connecting the shock corded poles.
(illus. 2)
Connect Tent to Frame
–Unfold and position the tent with the door
facing the desired direction. (illus. 3)
– Attach the poles to the tent corners using
the pin & ring system by inserting the pin
into the end of the pole. Repeat for each
corner. (illus. 4 & 5)
–Stake down tent corners by inserting tent
stake through the ring of the pin & ring
system. (illus. 6)
10’x8’ Outdoorsman
™
Tent
1
2
When You Are Ready To Set Up Your Tent
–Select a level campsite clear of rocks, branches and
other hard or sharp objects.
–Do not set up your tent under trees.
–For best results in windy conditions, position the end
of tent into the wind.
–See owners manual for more tips.
Instructions apply to Part Number 9280A108
illus. 1
illus. 2
illus. 3
illus. 4
Tent Frame
Part No. 9280-103
Rainfly Part No. 9280A101
POLE ASSEMBLY PARTS
illus. 5
Pin & ring system
illus. 6 Stake
corners through the
pin & ring system

Coleman 9280A108 Specifications

General

Brand	Coleman
Model	9280A108
Category	Tent
Language	English

Summary

Frame Pole Assembly

Frame Design

The tent frame features a unique one-piece, shock-corded design for easy assembly.

Step 1: Assemble Ridge Pole

Assemble the primary ridge pole by connecting its sections.

Step 2: Extend Tent Legs

Extend each leg of the frame fully by connecting the shock-corded poles.

Connect Tent to Frame

Tent Placement

Unfold and position the tent with the door facing the desired direction.

Attach Poles to Corners

Attach poles to tent corners using the pin & ring system by inserting the pin into the pole end.

Stake Tent Corners

Stake down tent corners by inserting tent stakes through the rings of the pin & ring system.

Clip Tent to Frame

Attach Ridge Frame Clips

Starting at the top rear, attach tent to frame using clips, then to the ridge pole.

Attach Side Frame Clips

Attach all remaining side frame clips to the tent frame.

Attach Rainfly

Position Rainfly

Drape the rainfly over the tent frame and insert frame poles into reinforced pockets.

Secure Rainfly Attachments

Attach rainfly to frame poles using S-hooks and secure corner/side guylines.

Important Tent Care and Safety

Condensation Management

Condensation can form; minimize it with ventilation and by removing wet items.

Storage and Maintenance

Dry tent thoroughly before storage; do not leave poles telescoped.

Stake Removal

Remove stakes by pulling on the stake itself, not the tent fabric.

Flammability Warning

Keep all flame and heat sources away from tent fabric; it meets flammability standards.