Preparing for Your New Portable Spa
8
Coleman
®
Spas (online sales)
LTR50001135, Rev. A
Coleman logo (white)
<----------
Filling and Powering Up Your Portable Spa
Inspect the spa equipment.1.
Fill the spa.3.
Neverllyourspawithsoftwater.
Soft water makes it impossible to maintain
the proper water chemistry and may cause
the water to foam, which will ultimately
harm the nish of the spa and void your
warranty.
Remove the cartridge from lter canister.2.
Place a garden hose in the fi lter canister and fi ll your spa
with regular tap water about six inches from the top.
If the water level is too low or too high, your spa will not
operate properly.
Always fi ll the spa through the fi lter canister! Failure
to do so may cause air to be trapped in the fi ltration
system and prevent the pumps from operating
properly.
Unscrew the cartridge and remove it.
After you remove the fi lter, remove the plastic wrapper
and soak it in water for 30 minutes before you replace
it. A dry fi lter can allow air into the fi ltration system
which can cause the pump to fail to prime.
After the spa has been placed on an approved surface and
has been correctly wired by a licensed electrician, inspect
all plumbing connections in the equipment area of your spa.
Ensure that these connections are secure and that they did
not loosen during shipment.
If your spa has gate valves, make sure they are all in the
UP or OPEN position.
Never run the spa with the gate valves closed or without
water circulating for long periods of time. Be careful not to
over-tighten the plumbing ttings.
To Next Page
Loading...
Need help?
General
