Operating Your Spa
11
Coleman logo (white)
<----------
Coleman
®
Spas (online sales)
LTR50001135, Rev. A
Operating Your Spa
Electronic Control Operation
These instructions will describe features and options that your particular spa may not be equipped with.
Initial Start up
When rst powered up, your spa will perform a self-
diagnostic check and go into priming mode. When
the control panel displays PR, IMMEDIATELY do the
following:
Press the 1. Jets or Jets 1 button to turn on the
pump and let it run for 10 seconds. The pump
should be running in low speed.
Press the 2. Jets or Jets 1 buttons again and let the
pump run in high speed for 10 seconds.
Press the 3. Jets or Jets 1 button again to turn
off the pump. The pump should be left in the off
position for 10 to 15 seconds.
Repeat steps 1 through 3 until water is fl owing 4.
through all the jets and all air is removed from the
plumbing.
When the spa has nished priming, the heater will be
activated and the water temperature will be maintained
in standard mode. The spa will heat to 100°F (37.5°C)
at start up until the set temperature is changed as
described below.
VS520 two pump system
(six button control panel)
(six button control panel)
VS300 single pump system
(four button control panel)
(four button control panel)
To Next Page
Loading...
Need help?
General
