Cleaning and Maintenance
28
Coleman
®
Spas (online sales)
LTR50001135, Rev. A
Coleman logo (white)
<----------
Cleaning Your Spa
Spa Cover and Pillows
Due to the constant punishment your spa cover and pillows receive, you should protect them by
applying spa-safe Vinyl and Leather Cleaner as part of your monthly maintenance plan. It is speci cally
designed to protect spa covers and pillows from chemical and ultraviolet light damage. It accomplishes
this without leaving an oily residue behind that is normally associated with common automotive vinyl
protectants.
Warning: Do not use automotive vinyl protectants on spa covers or pillows. These products are
generally oil-based and will cause severe water clarity issues that are dif cult to correct.
Spa Shell
Each time you drain your spa, before you re ll it you should clean your spa shell with spa-safe All-
Purpose Cleaner and apply a protective coat of Fast Sheen.
Spa-safe All-Purpose Cleaner is a low detergent, non-abrasive cleaner speci cally formulated to clean
the spa without damaging its acrylic nish.
Spa-safe Fast Sheen is a non-oil based wax that is speci cally formulated to protect the spa’s nish
from the chemicals and minerals associated with normal spa use.
Spray Multi-Purpose Cleaner directly to the spa’s nish.1.
Wipe clean with a soft cloth.2.
Repeat on heavily calci ed areas.3.
Wipe spa thoroughly with a wet sponge, rinsing often in a bucket of clean water.4.
Allow the spa to dry completely.5.
Apply a coat of Fast Sheen to the spa’s entire nish with a soft cloth or sponge.6.
Allow Fast Sheen to dry until white and powdery.7.
Buff clean with a soft cloth, rotating frequently.8.
IMPORTANT: Do not use any of these products on spas full of water. Only apply to clean, cool, dry
surfaces. Incorrect product usage may cause water clarity issues.
Removing and Reseating the Pillows
You can remove the pillows for cleaning and maintenance quickly and easily.
Grab the lower edge of the pillow with both hands rmly and pull up. As you do this, the pillow inserts will
pop out of the holes.
Reseat the pillows by aligning the pillow inserts with the holes and striking the pillow hard enough to insert
the pegs back into the holes.
To Next Page
Loading...
Need help?
General
