Operating Your Spa
13
Coleman logo (white)
<----------
Coleman
®
Spas (online sales)
LTR50001135, Rev. A
One pump systems
Press the • Temp
UP or Temp
DOWN button.
The temperature
setting will fl ash.
While the display is fl ashing, press the • Light
button. The display will show the next following
mode in the sequence (not the current mode).
To select the mode shown on the display, press •
Temp UP or Temp DOWN once again.
Two and three pump systems
Press the • Temp
UP or Temp
DOWN button.
Press the • Mode
button. The
display will show the next following mode in the
sequence (not the current mode).
Press • Temp UP or Temp DOWN followed by
Mode to cycle through the three heating modes.
Stop when the display shows the heating mode
you want.
(Range 80°F to 104°F, 26°C to 40°C)
The electronic control panel displays the actual water temperature in degrees
Fahrenheit. The displayed temperature will only be current after the pump has been
running for at least two minutes.
To display the temperature that the spa is set to:
Press the • Temp UP or Temp DOWN button. The temperature setting will fl ash.
While the display is fl ashing, each time you press the • Temp UP or Temp DOWN button, the set
temperature will change up or down one degree.
Temp
UP
Temp
DOWN
The spa can be set to operate in three different
heating modes:
Standard:• When the spa is powered up, it will
automatically start in Standard heating mode.
In Standard mode, the heating system will
automatically maintain the set spa temperature.
STD will light briefl y on the main display.
Economy:• In Economy mode, the heating
system will only activate during ltration times.
and will heat the water to the set temperature.
Ecn will display solid if temperature is not
current and will alternate with spa temperature
if measured temperature is current.
Sleep:• In Sleep mode, the heating system will
only activate the heater during the ltering cycles
but will only heat the water to within 20°F (10°C)
of the set temperature. Like Economy mode, SLP
will display solid when temperature is not current
and will alternate with actual temperature when
it is current.
NOTE: Displayed temperature will only be current
after the pump has been running for at least two
minutes.
Temperature Adjustment
Heating Modes Switching Heating Modes
JETS 1
JETS
MODE
JETS 2
JETS 3
JETS 1
JETS
MODE
JETS 2
JETS 3
To Next Page
Loading...
Need help?
General
