MAINTENANCE
WARNING
1.
Only a qualified technician should repair or inspect the vehicle. It is important to abide by all
procedures described in this manual and all safety signs such as "Danger", "Warning", or "Caution.”
2.
If a problem is found during routine maintenance or inspection, do not operate the vehicle until
the problem has been repaired.
3.
Wear proper safety apparel while repairing the vehicle. Proper safety apparel includes but is not
limited to: safety goggles or approved eye protection, insulated gloves, and a face mask.
4.
Remove all jewelry and loose apparel items.
5.
Use insulated tools while working on any electrical components.
6.
Set the key switch to Off and the FWD/REV switch to Neutral. Use chocks to secure the tires.
7.
Components such as the motor, controller, and resistor may become hot during operation. To
avoid burns, allow these components time to cool before performing service on the vehicle.
To Next Page
Loading...
