Charging the E-Merge
DANGER
• Do not use charger if:
o The plug is loose or does not make good contact.
o The plug or wires get hot.
o The connector pins are bent or corroded.
o The plug, receptacle, or connector is damaged in any way.
• Using charger with any of the above issues could result in a fire and/or personal injury.
• Always utilize a charger cord sized for heavy power loads, consult an electrician in the event of any doubt.
WARNING
• Inspect cords and connections for cracks or fraying. Replace if any
problems are found. Make sure all connectors are clean and dry.
• Use the yellow charger plug to connect to the vehicle receptacle. Do
not pull on the charger wires.
• With the charger properly plugged into the AC outlet. The charger
will analyze the battery’s condition and activate within 10 seconds.
The charger indicator lights will flash one by one and then
return to
indicating the state of charge.
Note: The charger is built into the vehicle. Due to the heat caused when
charging, the seat should be raised when charging in hot weather conditions.
The charger will automatically apply sufficient power to bring the E-Merge’s batteries to full charge. It will also
automatically shut itself off when they are fully charged. If left connected, the charger will occasionally check
the batteries’ condition and apply enough power to maintain a full charge.
It is recommended to plug the charger in even after short trips (10 minutes). This will assist in getting the
maximum life from your E-Merge’s batteries.
Visit charger manufacturer’s website www.lesterelectrical.com, for more details and maintenance tips.
To Next Page
Loading...
