Manual FLOW 38 Page 27 (total 54) COMAC CAL s.r.o.
Flow meter settings
The meter can be reconfigured in Settings menu. In the case of first requirement for reconfiguration (E-button
is pressed), the user is asked for password insertion. If the password is valid, it is possible to reconfigure
individual items until the user exits Settings menu. The default value for user password is 0000.
All modifications need to be confirmed prior to new saving.
*Note: Some modifications may not be valid right after saving but these will become valid after
reinitialization of the meter - refer to special button functions – REBOOT
Date and time
This menu item is in DD/MM/YYYY HH/MM formats.
Use the and buttons to set the menu item on the display and press the E to edit. Implement settings
in a standard way, using the setting buttons and confirm by pressing the E button.
It is necessary again to confirm the change.
Operation time counter
The counter registers the operation time of the meter (switching on). The first line indicates the date
when the last counter reset was performed and the second line indicates the length of operation in days,
hours and minutes.
This counter can be reset by pressing the E button when necessary.
Power loss counter
The counter registers the time of loss of power time for the meter. The first line indicates the date
when the last reset of power loss counter was performed and the second line indicates the length of
time when the meter was out of operation in days, hours and minutes. The counter can be reset again
by pressing the E button.
To Next Page
Loading...
Need help?
General