COMAC CAL FLOW 38

To Next Page

To Previous Page

Manual FLOW 38 Page 3 (total 54) COMAC CAL s.r.o.

Flow sensor cleaning ............................................................................................................................. 52

Servicing ................................................................................................................................................. 52

Order code .............................................................................................................................................. 53

Returning the meter to COMAC CAL s.r.o. .......................................................................................... 54

Main Page

Default Chapter2
- Table of Contents2
Description of Device4
- Scope of Delivery4
Storage Conditions5
Warranty5
Installation in Pipeline6
- Important Information for Selection of Location6
- Sources of Disturbances6
- Installation Examples7
- Actual Installation in Pipeline9
- Installation Check16
Wiring17
- Important Information17
- Installation of the Meter's Detached Evaluation Unit18
- Meter Wiring19
- Out1 / Out220
- Current Output21
- The External Button to Reset the User Volume Vnull22
- Data Output22
- Protection Degree22
- Replacement of Tube Fuse in the Meter23
- Wiring Check23
Putting into Operation24
Flow 38 Operating Instructions25
- Basic Button Functions25
- Special Button Functions25
- Password Setting25
- Basic Menu26
- Flow Meter Settings27
Expansion Module38
Turning the FLOW 38 Display41
- User Adaptation41
Technical Data43
Factory Settings45
Table with Flow Ranges for Individual DN Sizes47
Basic Sensor Sizes47
Nomogram for Quick Proposal of the Measured Place51
Reduction in DN Pipe51
Flow Sensor Cleaning52
Servicing52
Faults and Their Symptoms During Measurement52
Order Code53
Returning the Meter to COMAC CAL S.r.o54

COMAC CAL FLOW 38 - Page 3

Table of Contents

Other manuals for COMAC CAL FLOW 38