COMAC CAL FLOW 38 - Page 31

Manual FLOW 38 Page 31 (total 54) COMAC CAL s.r.o.
Current output
In current output parameter setting, you can set up the flow direction to which the current loop should
respond, to change the limits of current loop for 4mA, 20mA and possibly to perform calibration of this
current loop.
Current loop calibration can be carried out by changing the Offset value.
Error – service is always required
Warning – setting is out of parameters
All – warnings + errors
±Q – both flow directions (0 l/h = 12mA)
+Q – positive flow direction
ΣQ – both flow directions ( abs(Q) )
- Q – negative flow direction
Number of significant digits: 6
±Q – both flow directions
+Q – positive flow direction
ΣQ – both flow directions
- Q – negative flow direction
Number of significant digits: 6
+ = calibration to positive values
– = calibration to negative values
0÷99