IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
capacitive and "R" is resistive load (power factor = 1).
Value: Pwr factor L3
Generator power factor in phase L3.
Value: Load char L3
Character of the generator load in the L3 phase. "L" means inductive load, "C" is
capacitive and "R" is resistive load (power factor = 1).
Value: Gen freq
Generator frequency. The frequency is measured in the phase L3.
Value: Gen V L1-N
Generator voltage in phase L1.
NOTE:
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint VT ratio.
Value: Gen V L2-N
Generator voltage in phase L2.
NOTE:
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint VT ratio.
Value: Gen V L3-N
To Next Page
Loading...
Need help?
General
