ComAp IG-NTC-BB - Page 352

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
352
register #46361 and command #26.
NOTE:
See the Remote switches chapter in the InteliMonitor help for details about how to
control the output from InteliMonitor and the Modbus chapter in the latest
communication guide for information about control the output using Modbus.
Binary output: RemoteControl5
Related FW
3.0
Description
This is a general purpose output, which can be closed and opened remotely, e.g.
from InteliMonitor using the "Remote switches" tool or via MODBUS using the
register #46361 and command #26.
NOTE:
See the Remote switches chapter in the InteliMonitor help for details about how to
control the output from InteliMonitor and the Modbus chapter in the latest
communication guide for information about control the output using Modbus.
Binary output: RemoteControl6
Related FW
3.0
Description
This is a general purpose output, which can be closed and opened remotely, e.g.
from InteliMonitor using the "Remote switches" tool or via MODBUS using the
register #46361 and command #26.
NOTE:
See the Remote switches chapter in the InteliMonitor help for details about how to
control the output from InteliMonitor and the Modbus chapter in the latest
communication guide for information about control the output using Modbus.
Binary output: RemoteControl7
Related FW
3.0
Description
This is a general purpose output, which can be closed and opened remotely, e.g.
from InteliMonitor using the "Remote switches" tool or via MODBUS using the
register #46361 and command #26.
NOTE:
See the Remote switches chapter in the InteliMonitor help for details about how to
control the output from InteliMonitor and the Modbus chapter in the latest
communication guide for information about control the output using Modbus.
Binary output: RemoteControl8
Related FW
3.0
Description
This is a general purpose output, which can be closed and opened remotely, e.g.
from InteliMonitor using the "Remote switches" tool or via MODBUS using the
register #46361 and command #26.
NOTE:
See the Remote switches chapter in the InteliMonitor help for details about how to
control the output from InteliMonitor and the Modbus chapter in the latest