ComAp InteliSys NTC BaseBox User Manual

IGS-NT Communication Guide
145
User Modbus registers are assigned in the GenConfig as a standard part of configuration. See the figure below
for more information on how to assign a register. Assigned registers can be written and read the same way as
standard registers (refer to the chapter above).
It is still possible to read the assigned object on its original register address if required.
6 back to Modbus Connection

ComAp InteliSys NTC BaseBox Specifications

General

Brand	ComAp
Model	InteliSys NTC BaseBox
Category	Controller
Language	English