To Next PageTo Next Page
Need help?Do you have a question about the ComAp IS-NTC-BB and is the answer not in the manual?
General| Number of binary inputs | 8 |
|---|---|
| Protection Rating | IP20 |
| Supply voltage | 8-36 V DC |
| Operating temperature | -40 to +70 °C |
| Communication interfaces | CAN, RS485 |
| Protection | Overvoltage, reverse polarity |
Application overview for single parallel island operation of asynchronous generators.
Details procedures for safely disconnecting the controller for maintenance.
Describes the four primary operational modes: OFF, MAN, SEM, AUT.
Explains automatic mode, including remote start/stop and mains synchronization.
Explains the automatic tripping of unessential loads during island operation.
Lists and describes various active power control modes like Baseload, Import/Export.
Details the sequence and parameters for engine starting.
Describes normal and forced engine stop sequences and issues.
Details generator voltage/frequency protection settings.
Details mains voltage/frequency protection settings.
Lists and describes gen-set operational states like Ready, Cranking, Running.
Details binary inputs used for control functions.
Explains the remote start/stop binary input function.
Describes the emergency stop binary input and its behavior.
Describes access lock and remote mode control inputs.
Describes starter, fuel, and stop solenoid outputs.
Explains GCB ON, OFF, and UV coil outputs.
Describes alarm outputs and button echo outputs.
Describes horn and common alarm outputs.
Describes outputs for emergency stop, overspeed, underspeed, start fail, etc.
Details outputs for mains voltage/frequency alarms.
Details outputs for generator voltage/frequency alarms.
Explains password protection levels for setpoints.
Selects control mode for parallel operation.
Sets base load and selects measurement source for power.
Selects measurement source and sets peak load levels.
Sets gen-set name, nominal power, and current limit.
Sets the nominal generator voltage (phase to neutral).
Sets nominal mains voltage (phase to neutral/phase).
Selects phase-to-neutral or phase-to-phase for voltage protections.
Sets the nominal generator frequency.
Sets nominal RPM, controller mode, and gear teeth.
Configures IP address, net mask, and gateway.
Selects fixed or automatic IP address configuration.
Covers essential engine parameters like RPM and oil pressure.
Configures engine stop behavior and fuel solenoid function.
Configures alarm reset and overspeed protection threshold.
Specifies overload level and IDMT curve shape.
Sets short current level and IDMT curve shape for overcurrent.
Sets thresholds for generator over/under voltage.
Sets frequency and earth fault protection thresholds.
Sets thresholds for voltage and current unbalance alarms.
Sets thresholds for mains over/under voltage.
Sets thresholds for mains over/under frequency.
Selects speed governor characteristic and sets dwell time for RPM matching.
Sets speed governor limits and load ramp parameters.
Sets RPM matching, gain, and integration factors for speed/load control.
Sets timeouts for GCB opening and RPM matching.
Guides on adjusting load control parameters.
Guides on adjusting RPM matching and load control.
Selects when load shedding is active.
Sets load shedding levels, delays, and reconnection modes.
