ComAp IS-NT-BB - User Manual

Compact Controller for Stand-by and Parallel Operating Gen-sets
Inteli New Technology
Modular Gen-set Controller
Single Parallel Island application for Asynchronous
Generators
IG-NT, IG-NTC, IG-NT-BB, IG-NTC-BB, IS-NT-BB, IS-NTC-BB
Software version IGS-NT-Async-1.2, February 2011
USER GUIDE
Copyright © 2005 ComAp s.r.o.
ComAp, spol. s r.o.
Kundratka 2359/17
180 00 Praha 8
Tel.: +420 246 012 111
info@comap.cz
, www.comap.cz

Summary

Functions

OFF-MAN-SEM-AUT mode

Active Power control modes in SPI

Load shedding

Configuration and operation of load shedding stages with binary outputs.

Protections and Alarm management

Inputs and Outputs

Binary inputs - Control

Configuration of binary inputs for control functions like Remote start/stop, Emergency stop.

Binary outputs

Description of various binary outputs for system status and control like Starter, Fuel solenoid.

Setpoints

ProcessControl

Configuration of Load control modes: Baseload, IM/EX, ANEXT BASELOAD, ANEXT IM/EX.

Engine parameters

Starting RPM

Setting the engine speed for stopping cranking and enabling under-speed protection.

MaxCrank time

Idle time

Generator protections

OverldStrtEval

Specifies the overload level where the protection evaluation starts.

Min Power PtM

Mains protect

Mains >V MP

Threshold for mains over voltage protection.

Mains <V MP

Threshold for mains under voltage protection.

RPM;Load control

Dwell time

RPM matching

Controller configuration and monitoring

Direct connection to the PC

GenConfig functions

Overview of PC software functions for controller setup, module addressing, and language.

ComAp IS-NT-BB Specifications