To Next PageTo Next Page
Need help?Do you have a question about the ComAp InteliGen NTC BaseBox and is the answer not in the manual?
General| Controller Type | Generator Controller |
|---|---|
| Input Voltage | 8-36 V DC |
| Supply Voltage | 8-36 V DC |
| Relative Humidity | 95% non-condensing |
| Protection Rating | IP20 |
| Communication Interfaces | CAN, RS232, RS485, Ethernet |
| Storage Temperature | -40 to +80 °C |
| Weight | Approx. 0.5 kg |
| Certifications | CE, UL |
How to establish a direct internet connection for remote monitoring.
Setup for internet connectivity using the AirGate service.
Introduction to the WebSupervisor system for remote monitoring.
Details on accessing controller data via a web browser interface.
Details on the I-LB+ local bridge for CAN bus communication.
Lists and explains commands for the IGS-NT controller.
Lists and explains commands for the IM-NT controller.
Guidelines for setting up CAN and RS485 connections correctly.
Recommended cables for various communication interfaces (RS232, RS485, USB, CAN).
How to send commands to controllers via SMS messages.
Comprehensive guide to Modbus communication protocols and usage.
Practical examples demonstrating Modbus communication scenarios.
Details on converting between RS232 and RS485 protocols.
A step-by-step guide to establishing Modbus connections.
Detailed explanation of the Modbus protocol.
Specifics of the Modbus TCP protocol and its implementation.
Details on the Modbus RTU protocol.
