ComAp InteliGen NTC BaseBox

IGS-NT Communication Guide
62
5 Controller setup
5.1 Displays 62
5.2 Comms extension - I-LB+ Local bridge 64
5.3 I-CR Module for CAN Bus Extension 67
5.4 I-CR-R Module for CAN Bus Redundancy 68
5.5 I-CR-R module properties 70
5.6 Commands for IGS-NT 72
5.7 Commands for IM-NT 75
6 back to Table of contents
5.1 Displays
5.1.1 InteliVision 12Touch display
Controllers
Controllers IG-NT-BB IG-NTC-BB IS-NTC-BB IM-NT-BB IM-NTC-BB
Connectionapplicable YES YES YES NO YES
Physical port RS485 (1) RS485 (1) RS485 (1) - RS485 (1)
Controllers IG-NT IG-NTC IS-NT-BB IM-NT
Connectionapplicable NO NO NO NO
Physical port - - - -
Note: For more information please see www.comap-control.com/products/detail/intelivision-12touch