To Next PageTo Next Page
Need help?Do you have a question about the ComAp InteliGen NT BaseBox and is the answer not in the manual?
General| Model | InteliGen NT BaseBox |
|---|---|
| Digital Inputs | 8 |
| Analog Inputs | 4 |
| Analog Outputs | 2 |
| Operating Temperature | -20 to +70 °C |
| Protection Class | IP20 |
| Communication Ports | RS232, RS485, Ethernet |
| Humidity | 95% non-condensing |
| Supported protocols | Modbus, CAN, J1939 |
| Storage Temperature | -40 to +85 °C |
Methods for connecting a PC directly to a single gen-set for communication.
Connecting controllers via USB for data transfer and configuration.
Establishing communication using RS485 serial connections.
Methods for connecting a PC to multiple gen-sets for communication.
Connecting controllers via I-LB+ module using RS232/RS485.
Connecting controllers via USB using the I-LB+ module.
Connecting controllers via Ethernet using the IB-NT bridge.
Direct Ethernet connection for controller monitoring and configuration.
Describes local site monitoring using the MODBUS protocol.
Explains Modbus communication for multiple gen-set systems.
Modbus communication via I-LB+ using RS232/RS485.
Modbus communication via Ethernet using the IB-NT bridge.
Setting up direct internet connection for controller monitoring.
Using AirGate for internet connection without static IP addresses.
Overview of WebSupervisor system for monitoring and control.
Accessing controller data and settings via a web browser.
Connecting controllers via cellular networks using InternetBridge-NT.
List and explanation of commands for IGS-NT controllers.
List and explanation of commands for IM-NT controllers.
Guidelines for proper CAN and RS485 physical connections.
Overview of Modbus communication protocols and setup.
Practical examples of Modbus communication scenarios.
A step-by-step guide for establishing Modbus connection.
Key controller settings required for Modbus communication.
Configuring Modbus communication over RS232 for a single controller.
Configuring Modbus communication over RS485.
