IGS-NT Communication Guide
93
7.4 Examples of Modbus Communication
In this chapter are some examples, how does communicate controller via Modbus.
7.4.1 Battery voltage – reading (read multiple registers) 94
7.4.2 Values (Oil press, Water temp, Fuel level) – reading 96
7.4.3 Binary input - reading 97
7.4.4 Password decode - reading 97
7.4.5 Gen-set name - reading 98
7.4.6 Engine state - reading 99
7.4.7 Gear teeth – writing 100
7.4.8 Nominal Power – writing 100
7.4.9 Mode – writing 101
7.4.10 Reset/Confirm Alarm 102
7.4.11 Remote Switch 1-8 – Set (Remote Control 1-8) 103
7.4.12 External Value1 – writing 104
7.4.13 User & Password – in two steps 105
7.4.14 User & Password – in one step 106
7.4.15 Start the engine – in one step 106
7.4.16 Start the engine – in two steps 107
7.4.17 History – reading 107
7.4.18 AlarmList reading 109
7.4.19 Change the communication language (only String type data) 110
To Next Page