ComAp IS-NT-BB

IGS-NT-BC, SW Version 1.2.0, ©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
171
Click on button with "..." to get a clear list of BI names with their corresponding
values.
Value: LogBout 3
Group
Log bout
Units
-
Related FW
3.0
Description
This is a bit array containing status of logical binary outputs 33-48 of the
controller. Bit0 represents LBO33, bit1 represents LBO34 etc..
NOTE:
All terminals display binary values in "human-readable" form - from left to right.
That means the bit 0 is displayed in the most left position. This is different from
common use in computer science, where binary values are displayed from right to
left.
NOTE:
Click on button with "..." to get a clear list of BI names with their corresponding
values.
Value: LogBout 4
Group
Log bout
Units
-
Related FW
3.0
Description
This is a bit array containing status of logical binary outputs 49-64 of the
controller. Bit0 represents LBO49, bit1 represents LBO50 etc..
NOTE:
All terminals display binary values in "human-readable" form - from left to right.
That means the bit 0 is displayed in the most left position. This is different from
common use in computer science, where binary values are displayed from right to
left.
NOTE:
Click on button with "..." to get a clear list of BI names with their corresponding
values.
Value: LogBout 5
Group
Log bout
Units
-
Related FW
3.0
Description
This is a bit array containing status of logical binary outputs 65-80 of the
controller. Bit0 represents LBO65, bit1 represents LBO66 etc..
NOTE:
All terminals display binary values in "human-readable" form - from left to right.
That means the bit 0 is displayed in the most left position. This is different from
common use in computer science, where binary values are displayed from right to