3.3 OPTIONAL ACCESSORIES
It is possible to integrate the standard equipment of the water cleaner with the following rich range
of accessories:
• sanding lance (maximum use temperature of 60°C);
• double-cane lance;
• hose venting probe (maximum use temperature of 60°C);
• underbody lance;
• rotating water brush (maximum use temperature of 60°C);
• rotojet (maximum use temperature of 60°C);
• rotating hose winder.
« CAUTION
• Unsuitable optional accessories endanger the good operation of the water cleaner and can make
it dangerous. Only use original optional accessories authorised by the Producer.
As regards the general prescriptions, the safety warnings, the installation and the maintenance
of the optional accessories, it is necessary to refer to the documentation accompanying them.
4. INSTALLATION
Also refer to Fig. 4 at the beginning of this use and maintenance manual.
4.1 MOUNTING THE ACCESSORIES
• Mount the lance support (36) by means of the suitable fixing and the two supplied screws.
• Mount the nozzle (34) on the head (33) of the lance hose (32), by well locking it by means of
a 14-mm pipe wrench (not supplied). Operation A of Fig. 4.
• Screw the end of the high-pressure hose (29) (side without fast coupling) on the water gun (31)
thread and well tighten with a 22-mm fixed wrench (not supplied): Operation B of Fig. 4.
• Insert the fast-coupling connector (28) on the water outlet connector (22), screw and tighten
manually. Operation C of Fig. 4.
• Insert the water suction filter (23) in the water inlet connector (25) by paying attention to
position the projecting side of the filter inside the connector. Operation D of Fig. 4 (only KE
Classic).
4.2 CHECKING AND CONNECTING THE ELECTRICAL LINE
WARNING
• The water supply must be such to guarantee a suitable supply of water capacity for the water
cleaner. On this respect, refer to the values reported in the technical data table.
In case of doubts, apply to a Skilled Engineer.
• Do not supply the water cleaner with water at a temperature which is higher than 60°C or lower than 5°C.
• The water pressure must be never higher than 8 bars.
• Do not operate the water cleaner without water supply.
• Do not supply the water cleaner with salt water or water containing dirt. In case this happens,
operate the cleaner with clean water for some minutes.
« CAUTION
• Observe the prescriptions for the connection to the water line which are valid in the
country where the water cleaner is installed.
To Next Page
Loading...
