COVER series MZ – User manual
COMEX S.A.
Figure 2-1 View of the sample power supply after disassembling the packaging
Note: Remove the screws that connect the UPS enclosure to the wooden pallet, then place the
power supply at the point of installation using the exit provided in the UPS enclosure.
Disassembly should be carried out carefully so as not to damage the housing.
The 60kVA power supply is equipped with brake wheels, and the 80kVA power supply has
additional feet to stabilize the UPS after it has been positioned at its destination, as shown
below.
Check the correctness of the delivered equipment on the label located on the back of the UPS
door. The label contains basic information about the model, power, etc.
Note: Dispose of the safety materials (wood, plastic, etc.) after disassembly in accordance with
the applicable local environmental regulations.
In order to extend the service life of the device, it is necessary to provide a suitable place for its
installation, which should guarantee:
To Next Page
Loading...
General