COMGROW T-500 - Printer Controls: Movement and Temperature; Axis Movement and Homing Procedures; Temperature Management Settings

Move
Temperature
1. Cancel heating for all
2. Adjust temperature
3. Preheat PLA
4. Preheat ABS
5. Preheat PETG
6. Preheat FLEX
7. Reduce the temperature
8. Raise the temperature
9. Increase/decrease
temperature per click
10
 



Homing
X+: Move X axis to right
X-: Move X axis to left
Y+: Move Y axis forward
Y-: Move Y axis backward
Z+: Move Z axis up
Z-: Move Z axis down
1. Homing
2. Disable Motors
3. X/Y/Z axis’s current coordinates
4. Settings
5. The distance per move
Move
Settings
1. Reverse the movement direction
2. Adjust the speed of moving X/Y axis
3. Adjust the speed of moving Z axis



 




1. X/Y/Z axis all auto home
2. X axis auto home
3. Y axis auto home
4. Z axis auto home
5. X/Y axis auto home
6. Z tilt
Temperature
 
 
 


