COMGROW T-500 - Bed Calibration Procedures; Bed Mesh Configuration Steps; Z Axis Offset Calibration Steps

12


 
 

Z Calibrate
1. Start Z calibrate
2. The value of Z calibrate
3. Raise nozzle according to the setted height
4. Apply the settings (Saving settings requires a
system restart)
5. Lower nozzle according to the setted height
6. Abort Z calibrate
7. Set the distance of per move
Z Calibrate
Bed Mesh
Bed Mesh
1. Add profile
2. Clear the saved leveling data in current profile
3. Start calibrate
4. Leveling data preview
5. Current profile name
6. Delete current profile





