Comm-Tec DAN-B202 - Page 19

19
Dante interface 2x2
Commands List
Command
Function
Example and Feedback
livol,port:x
Set the gain of input.
Port=1,2 means input 1 or input 2
x=0,1,2,3…8 6dB step
livol,1:3
ok/error
getlivol:port
Query gain of input.
Port=1,2 means input 1 or input 2
getlivol:1
ligain,1:3 18dB
phantom,port:on
/off
Power on/off of phantom power.
phantom,1:on
ok/error
getphantom:port
Query status of phantom power.
getPhantom:1
phantom,1:on
lovol,port:x
Set the gain of output.
Port=1,2 means output 1 or output 2
x=0,1,2,3…100
lovol,2:80
ok/error
getlovol:port
Query the gain of output.
Port=1,2 means output 1 or output 2
getlovol:2
lovol,2:80
mute:port
Mute the output.
Port=1,2 means output 1 or output 2
mute:1
ok/error
unmute:port
Unmute the output.
Port=1,2 means output 1 or output 2
unmute:1
ok/error
getmute:port
Query status of mute.
Port=1,2 means output 1 or output 2
getmute:1
mute,1:off
parameterlockon
Lock the parameter.
ok/error
parameterlockof
f
Unlock the parameter.
ok/error
identifyon
Turn on the function to be identified.
ok/error
identifyoff
Turn off the function to be identified.
ok/error
locate
Locate the unit, turn on the function
to be identified. The LEDs on front
panel will twinkle, and continue until
identifyoff is sent.
ok/error