Comm-Tec DAN-B202 - Page 20

20
Dante interface 2x2
savepresetaudio
Save the current setting (input gain,
output volume, phantom power
status, mute status) to preset.
ok/error
loadpresetaudio
Use the saved preset.
ok/error
reset
Factory reset the unit.
ok/error
getaudiolevels
Query the status of the audio.
ligain,1:4 24dB
ligain,2:4 24dB
lovol,1:40
lovol,2:40
getsettings
Query the settings of audio.
ligain,1:4 24dB
ligain,2:4 24dB
phantom,1:on
phantom,2:on
lovol,1:40
lovol,2:40
mute,1:off
mute,2:off
getdeviceinfo
Query the status of the unit.
Model, name, version, Mac address.
Model:2x2 Dante
Interface
Name:DAN-B202-
C93512
MAC:44-33-4C-C9-35-12
Dante Version:4.2.2
GUI Version:1.0.0
Firmware Version:1.0.0
getdantelock
Query the lock status of the unit.
DanteLock:unlock
getsignals
Query the status of the audio.
(Invalid signal/Signal clipping/Valid
signal /No signal)
Input1:Nosignal
Input2:No signal
Output1:Valid signal
Output2:Valid signal
getchannellabel
Query the label of channel.
Input1 TX1
Input2 TX2
Output1 RX1
Output2 RX2
aes67on
Enable AES67
ok/error
aes67off
Disable AES67
ok/error