Commodore A 2091-40 - Page 42

5-6 The A2091 Installation Software Disk
P
Park
Double-click on this icon to park the drive heads on the partition named DHØ:. In
order to protect the hard disk, you should park the drive heads before turning your
system off.
If you have additional drives connected to the A2091 you will need to modify Park
in order to park the additional drives.
The partition on the Park command defaults to DHO:. For each additional partition
you will need to add that partition to the list of partitions to be parked. You can do
this through Workbench or through the CLI or Shell.
From Workbench:
You must add a tool type by clicking once on the Park icon and then selecting Info
from the Workbench menu. Click on ADD and then type:
PARTITION=partitionnamel:; |partitionname2:
Click on SAVE.
Note that PARTITION must be upper case, and there should not be a space between
partition names.
If you wish to shut down the partition so that it cannot be accessed, add a tool type:
INHIBIT
Note that INHIBIT must be upper case. INHIBIT is a global command that prevents
a hard disk from being accessed once any of its partitions have been parked. As
an example, if you have two hard disks in your system, each with three partitions,
and you list one partition from each disk under Park with INHIBIT, both hard disks
will be inaccessible once the Park program is run.
From CLI or Shell type:
park partitionl: partition2:
If you wish Park to shut the partitions down so that they cannot be accessed, type:
park partitionl: partition2: INHIBIT
Park defaults to DHO: unless otherwise specified.