Commodore A 2091-40 - Page 51

The A2091 Installation Software Disk 5-15
If you wish to change to that drive type, click on
Continue. If you do not wish to change to that drive
type, click on Cancel. n)
If there are more drives types listed than can be
displayed in the list at one time, you will need to
scroll the list up or down. To scroll the contents you
can either click on the arrows at the right of the
window, or drag the scroll bar located between the
arrows.
Click on this box if you are adding a drive which is
nat listed. This will open the Define/Edit Drive Type
screen, so you can input the drive's specifications
as supplied by the drive's manufacturer. For
complete instructions please see the explanation of
the Define/Edit Drive Type screen.
If you wish to change the specifications of a drive
that is already listed, click on that drive type, and
then click on Edit old drive type. This will open the
Define/Edit Drive Type screen, so you can change
the listed specifications. For complete instructions
please see the explanation of the Define/Edit Drive
Type screen.
If you wish to delete a drive from the Drive Types
list, click on the drive type to be deleted, and then
click on Delete old drive type.
Click on this box to save the changes to this screen
and to return to the Hard Drive Preparation,
Partitioning and Formatting screen.
Click on this box to return to the Hard Drive
Preparation, Partitioning and Formatting screen
without saving your changes.