EasyManuals Logo

CommScope ION-M7P User Manual

CommScope ION-M7P
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
3 Commissioning
Page 31
7. Bring the plastic ring over the cable(s), push it into the backshell and compress
the seals and plastic ring by screwing the clamp ring tight (no gap) using a
spanner with opening 20. ***
8. Connect the plug to the optical-fiber
connector of the Remote Unit, again
by fitting a stamp on the plug into the
groove of the connector.
9. To lock the connector, push the black
locking ring forward.****
Screw tight until gap is closed
*** For disassembling, release the clamping ring and remove the seals and the plastic ring first.
**** Locking mechanism: The system of locking the plug is based on a “push-pull” mechanism. The
locking ring has to be pushed forward to lock the connector and pulled back to free the
connection.
3.5.2. Protective-Tube Kit
As additional protection for the optical fibers, this connector type can be
supplemented by a special tube kit. To fasten the tube correctly, first unscrew the
clamp ring (if already installed) of the original plug kit.
Then, proceed according to the following instruction:
Groove
Push forward to lock, pull
bac
k
to
fr
ee
co
nn
ect
i
o
n

Other manuals for CommScope ION-M7P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CommScope ION-M7P and is the answer not in the manual?

CommScope ION-M7P Specifications

General IconGeneral
BrandCommScope
ModelION-M7P
CategoryRemote Control
LanguageEnglish

Related product manuals