Community D SERIES - Page 9

D SERIES Ceiling Loudspeakers Installation and Operation Manual Page 9
Figure 4. Internal wiring between can terminal block and loudspeaker
Internal wiring between terminal block
and plug-in connector to loudspeaker
(factory wired). Red arrows point to the
jumpers between the pairs of (+) and (-)
terminals in the highlighted area of this
image.
View of 6.5" loudspeaker showing the
location of the socket for the wiring
connector from the back can.
Close-up view of socket for the wiring
connector from the back can.
Connect the plug from the can (or from
the conduit wiring, see Figure 5) to this
socket on the loudspeaker assembly.
The loudspeaker is now connected to
the wires from the can and is ready to
mount in the can.
Note: It should be obvious that in these photos the loudspeaker and can are not in place
in a ceiling, but instead are arranged for photographic convenience.
Note: All electrical installation connections for loudspeaker lines are subject to
all applicable governmental building and fire codes. The selection of appropriate
electrical hardware to interface with the D SERIES loudspeaker lies solely with
the installation professional. Community recommends that an appropriately
licensed engineer, electrician, or other professional identify and select the
appropriate conduit, fittings, wire, etc. for the installation.
Installation and Wiring (continued)